Garages
See also: House Additions & Remodels, Accessory Dwelling Unit
What Is It?
A single-family garage is used to park a car and store items; it may be in a building separate from a house or it may be attached to a house.
What Permits Do You Need?
Construction permit - subject-to-field-inspection. Most new and remodeled garages require only a subject-to-field-inspection permit. To qualify, your garage needs to be 750 square feet or less, a single story without a roof deck, and with beams spanning 14 feet or less. In addition, the property where you will build your garage must not be in an environmentally critical area.
- Tip 316, Subject-to-Field-Inspection Permits
- Tip 103, Site Plan Guidelines and Requirements
Construction permit - addition or alteration. If your project doesn’t quality for a subject-to-field-inspection permit, you will need an addition or alteration permit. If your garage will be located in an environmentally critical area (such as a steep slope or flood-prone area) or if you need to dig an area over 750 square feet for your garage’s construction (including any driveway or other paved area), you need to schedule a pre-application site visit and we may have additional requirements.
- Tip 327A, Environmentally Critical Areas Exemptions, Relief from Prohibition on Steep Slope Development, and Modifications to Submittal Requirements
- Tip 327B, Environmentally Critical Areas — Small Project Waivers
Electrical or plumbing permit. You may also need to get an electrical permit or plumbing permit if your garage will be wired for electricity or have a sink. You may also need to apply for electrical service changes or new services from Seattle City Light.
Research the code
Our land use zoning and environmentally critical area codes limit the size and placement of your garage.
The combined footprint of your structures (including new garage), covered areas, and decks 36 inches or more above the ground can’t exceed a certain percentage of your lot size. That percentage depends upon your property’s land use zone.
In the Neighborhood Residential zone, we limit the total coverage of all structures to 50-60 percent of the lot area.
You usually can’t put a garage within the front 20 feet or the side 5 feet of your property. You may place your garage in your rear yard (within the last 10-15 feet), but we limit its size and height. We may also require a side setback agreement with your neighbor.
- Land Use Code (Seattle Municipal Code (SMC) Title 23)
- Neighborhood Residential Code
- SMC 23.44, Neighborhood Residential
If your garage will be located in an environmentally critical area, additional restrictions will apply. Please contact us through our SDCI Services page for coaching.
Your garage will also need to meet our building code requirements based on the Seattle Residential Code. For subject-to-field-inspection permits, we check those requirements when we inspect your project during construction. For addition or alteration permits, we check them during our review of your construction plans.
Should You Hire a Professional?
Garage drawings rarely require a professional stamp from an architect or engineer. Anyone with drafting skills may prepare the drawings, or you may hire a professional to help you.